Filter
Top Products
Noise, flickering
1 Use the remote control to adjust the sync first. Make
pixels, or distortion
sure you use the entire range of sync adjustments before yo
proceed to step 2. You can correct many severe-looking dis-
tortions by using sync.
Note: There are separate sync values for NORMAL and
SCALE modes. Sync adjustments made in one are not
applied to the other. Make adjustments in both.
2 If sync does not correct the problem, adjust the Dot Clock.
Make changes to this parameter slowly to avoid skipping
over the desired value. This may require some trial and
error.
3 If the problem still exists, adjust the VCO gain.
106 Troubleshooting