Filter
Top Products
6 Gently tilt the flip mirror approximately 45˚. (You can adjust
the angle later to raise or lower the projected image.)
Tilting the flip mirror
to a 45 degree angle
Caution: Never push on or force the mirror. Always use
care when opening the mirror assembly. Avoid touching the
surface of the mirror with your fingers.
Connecting the
Follow the instructions specific to your hardware.
computer
Connecting PCs
1 Disconnect your computer-to-monitor cable at the computer
end.
2 Connect the free end of the monitor cable to the VGA OUT
connector on the projector.
3 Use the Polaview VGA-to-LCD connector cable (part number
C800-6) to link the projector to the computer. Connect the
end of the cable marked LCD to the projector COMPUTER IN
connector, and the end marked COMPUTER to the comput-
er video-output connector.
Proceed to the section
Connecting video and audio
.
Introduction 7