Filter
Top Products
Projecting without an attached monitor
Some display cards rely on sense-line information from the
monitor to configure themselves for the correct display res-
olution. The absence of sense-line information causes some
display cards to output a default video signal and actually
prevents some video cards from outputting video at all.
If you connect the projector to a computer without a moni-
tor, turn on your system and check to see if the display reso-
lution is acceptable. If it is not, you need to set the sense
lines to make the projector emulate a monitor (see
Appen-
dix C: Sense lines
).
PCs
1 Disconnect your computer-to-monitor cable at the computer
end.
2 Connect the free end of the monitor cable to the VGA OUT
connector on the projector.
3 Use the Polaview VGA-to-LCD connector cable (part number
C800-6) to link the projector to the computer. Connect the
end of the cable marked LCD to the projector COMPUTER IN
connector, and the end marked COMPUTER to the comput-
er video output connector.
PC video-out
connection
to the projector
Detailed setup 25
Projector
PC
VGA to connector
cable