Filter
Top Products
DEC workstations
1 Disconnect your computer-to-monitor cable at the comput-
er end.
2 Connect the free end of the monitor cable to the DEC 3C3-to-
LCD adapter (part number C946).
3 Connect the free end of the DEC 3C3-to-LCD adapter to the
projector COMPUTER OUT connector.
4 Use the DEC 3C3-to-LCD connector cable (part number
C946-6) to link the projector to the computer. Connect the
end marked LCD to the projector COMPUTER IN connector,
and the end marked COMPUTER to the workstation video-
output connector.
Proceed to the next section,
Connecting video and audio
.
Connecting
Connect audio and video sources to the projector, using this
video and audio
table as a guide. If you need more information, see the
appropriate section in Chapter 2,
Detailed setup
.
To set this up: Connect this cable: From here: To here:
Video from Composite VIDEO 1, 2 RCA port on
VCR/ laserdisc audio/video ports on VCR marked
cable (C497-6) projector VIDEO OUT
or some-
thing similar
Video from S-video cable S-VIDEO 1, 2 VIDEO OUT
S-video (C466-6) ports on port on
device projector S-video
device
Audio from Composite AUDIO IN 1, 2 AUDIO OUT
VCR/laserdisc audio/video ports on projector port on VCR
cable (red = right, (red = right,
(C497-6) white = left) white = left)
Audio from Computer Left/right AUDIO OUT
computer audio COMPUTER port of the
cable AUDIO IN ports Mac or the
(C498-6) on projector sound card
of a PC
10 Introduction