Filter
Top Products
SpectraLink 8000 Telephony Gateway Administration Guide
to highlight Reset All Systems and press Enter. Respond with a Y
to the reset prompt.
7. For each Gateway, assign handsets to telephone lines controlled
by each SpectraLink 8000 Telephony Gateway per Chapter 13,
Telephone Line Configuration.
8. For each Gateway (using Send All as indicated): Establish feature
programming per Chapter 14 Features Programming Menu and the
LinkPlus Interface Guide for your telephone system.
9. At this point, the SpectraLink 8000 Telephony Gateway is
configured. The remaining steps are done on the handsets. These
steps are detailed in the handset administration document:
SpectraLink e340/h340/i640 Wireless Telephone Administration Guide
or SpectraLink 8020/8030 Wireless Telephone Administration Guide.
10. Configure, test and verify each handset.
11. Perform AP coverage test per Certifying the Wireless Telephones.
12. Call Customer Support at Polycom for Site Certification clearance.
Send All
Depending on your system configuration, each SpectraLink 8000
Telephony Gateway may have identical settings. Relevant selections,
such as DNS and WINS options, have an
S=Send All option allowing
you to send that configuration parameter to every SpectraLink 8000
Telephony Gateway on the LAN. Send All can only be used after the
IP address is established on EACH SpectraLink 8000 Telephony
Gateway via the serial connection. If you anticipate identical settings
across the LAN, set just the IP address and custom hostname (if
desired) for each SpectraLink 8000 Telephony Gateway using the
initial serial connection. Then connect via the LAN and use Send All
to set identical configuration options for all SpectraLink 8000
Telephony Gateways.
If Send All is to be utilized in your system, all passwords must be
identical. DO NOT CHANGE THE PASSWORD AT THE INITIAL
CONFIGURATION IF THE SEND ALL OPTION IS DESIRED. Use
the default password and change it globally if desired after a LAN
connection is established for all SpectraLink 8000 Telephony
Gateways.
If independent administration of each SpectraLink 8000 Telephony
Gateway is desired, the passwords may be set at initial configuration.
42 PN: 1725-36028-001_T.doc