Filter
Top Products
#9.
-/
2 Print a test page.
If you still have the problem, try steps 3 through 5 below.
3 Reinstall the OPC belt cartridge.
Print a test page after each step.
4 Replace the toner cartridges.
5 Replace the OPC belt cartridge.
See “Print Quality Problems” on page 8-28 for a further discussion of print quality
problems and possible solutions.
If you still can’t identify the problem, contact your local vendor.
0&#
Caution:
Although the QMS
magicolor
2 DeskLaser was designed for occasional
printing on a wide range of media types, it is not intended to print exclusively on a
single media type except plain paper. Continuous printing on media other than
plain paper (such as envelopes, glossy stock, labels, thick stock, transfer media, or
transparencies) may adversely affect print quality or reduce engine life.
After 200 1-sided pages (or 100 2-sided pages) of a continuous print run of plain
paper, the
magicolor
2 DeskLaser automatically pauses for 3 minutes to cool
down the engine. This occurs for monochrome or color printing. After this initial
cooldown pause, the printer automatically resumes its printing. From that point
forward while doing continuous printing, the 3-minute cooldown pause occurs every
50 pages until the continuous printing stops. After an extended idle period, this
50-page interval automatically resets to 200 pages. This process is provided to
maintain the rated duty cycle of the printer and to ensure reliable printer opera-
tion with optimum output quality.
In general, if you’re having output problems with your duplexer, try the following:
1 Ensure that you are using correct media.
Do not duplex envelopes, labels, or transparencies.