Filter
Top Products
$
%
.$
1 Take a stack of about 250 sheets (
½ ream).
»Note:
Don’t unwrap the paper above the printer as this might cause paper
particles to fall into the printer.
2 Holding the stack with one hand, fan the paper with the other.
This gets air through the sheets and prevents static buildup.
3 Take off the top and bottom sheets.
Residual glue buildup on these sheets may cause media jams.
Duplexing
Supported up to 28 lb bond (105 g/m²). See “Printing on Both Sides
(Duplex Printing)” on page 3-23.
Notes
We do not recommend using perforated or prepunched paper.
You should test any stock thicker than 24 lb (90 g/m²) to ensure that its perfor-
mance is acceptable.