Filter
Top Products
31
2. Use the number keys and
./DELAY to enter the frequency
(including the decimal point)
you want to store.
3. If you make a mistake, press
CLR to backspace and correct
the incorrect digit, or press
and hold
CLR for about 2
seconds to clear the entire
field and start over.
4. Press
ENTER to store the
frequency into the channel.
Ô
5. By default, the scanner will
configure the channels you
enter for a two second delay
after a transmission is
received. This is indicated by
the D character that appears
in the top row of the display. If
you do not want the scanner
to pause for reply traffic
before resuming scanning
operation, press
./DELAY until
D is not visible in the top line
of the display.
6. If necessary, press
MODE to
change the receiving mode.
Valid modes for conventional
frequencies include AM, FM/
Digital, CTCSS and DCS. To
program a specific code for
CTCSS or DCS mode, press
FUNC MODE, then enter the
desired code followed by
ENTER,orusetheS or T
keys to scroll to the desired
code and press
ENTER to
store the code with the
channel memory. For more
information on CTCSS and
DCS programming, see
“Programming channels for
Ô NOTES Ô
• Ifyoumadeamistake
in entering the
frequency,
Invalid Freq
briefly appears and
the scanner beeps
when you press
ENTER. Enter the
frequency again.
• Your scanner
automatically rounds
theentered frequency
to the nearest valid
frequency. For
example, if you enter
a frequency of
151.53, your scanner
accepts it as
151.5275. Reception
of the frequency will
not be adversely
affected.
• If you enter a
frequency that has
already been entered
elsewhereinthe
same bank, the
scanner sounds an
error tone and
displays
Dupl.f andthe
channel number that
has been duplicated.
If the dual entry is an
error press CLR and
enter the correct
frequency. If the dual
entry is intentional
press ENTER to
accept.
• You may replace any
frequency by
selecting the bank
and channel,pressing
PGM and entering the
new frequency.
•Youcanclear
programmed
frequency data by
pressing FUNC,then
CLR.
• If you make an error
in the entry process,
press CLRas often as
needed to erase the
incorrect data, or
press and hold CLR
for one second to
clear the entire field.