Filter
Top Products
33
PROGRAMMING
M
OTOROLA ANALOG,
D
IGITAL, AND APCO-25
T
RUNKING SYSTEMS
1. Press PGM and FUNC then S
or T to select the desired
channel storage bank to
program.
Ô
2. Press TRUNK to access the ID
list and set the correct
trunking bank type. If the bank
has never been programmed
with a trunking system, the
scanner will display
Not
trunked! Press mode
.
3. Press
MODE until Motorola
appears in the display. This
sets the channel storage bank
for Motorola operation.
4. Press
PGM to return to the
channel storage bank.
5. Select a channel to begin
programming trunking system
frequencies. Use direct
channel entry or the S or T
keys.
6. Enter the trunking frequency
and press
ENTER.If
necessary, press
MODE to
change the receiving mode to
MO (Motorola).
7. Repeat Steps 5 and 6 to enter
the other trunking system
control channel frequencies
for the system you wish to
monitor.
Ô NOTES Ô
•Youcanalsopress
FUNC,thenTRUNK
to access the ID list
from manual mode.
• When monitoring
Motorola trunked
radio systems, it is
only necessary to
program the trunking
control channel.
•ForAPCO-25
trunking systems
using the 9600 bps
control channel,
program the system
using the steps
outlined above for
Motorola systems.
Your scanner will
automatically detect
the proper control
channel type.
• Some systems rotate
the control channel
on a daily basis. For
best results, program
all known control
channel frequencies
into the trunking
channel storage
bank.
• To program Motorola
UHF trunking
systems, see
“Programming
Motorola VHF and
UHF Trunking
Systems” on
Page 34.
• To program Motorola
800 MHz “splinter”
systems, see
“Programming
Motorola 800 MHz
Splinter Systems” on
Page 36.
• To program Motorola
Type I/IIi fleet maps,
see “Programming
Fleet Maps” on
Page 36.