Filter
Top Products
34
PROGRAMMING EDACS
T
RUNKING SYSTEMS
1. Press PGM and FUNC, and
then S or T to select the
desired channel storage bank
to program.
Ô
2. Press TRUNK to access the ID
list and set the correct
trunking bank type. If the bank
has never been programmed
with a trunking system, the
scanner will display
Not
trunked! Press mode
.
3. Press
MODE until EDACS
appears in the display. This
sets the channel storage bank
for EDACS operation.
4. Press
PGM to return to the
channel storage bank.
5. Select a channel to begin
programming trunking system
frequencies. Use direct
channel entry or the S or T
keys.
6. Enter the trunking frequency
and press
ENTER.If
necessary, press
MODE to
change the receiving mode to
ED.
7. Repeat Steps 5 and 6 to enter
the other EDACS trunking
system channels for the
system you wish to monitor.
PROGRAMMING
M
OTOROLA VHF AND
UHF T
RUNKING SYSTEMS
Your scanner is capable of
receiving Motorola trunked radio
Ô NOTE Ô
It is necessary to
program all EDACS
system channels into
your scanner in Logical
Channel Number (LCN)
order, beginning with
LCN 1 in channel 01 of
the channel storage
bank. Do not program
EDACS system
channels in channel 00
of a channel storage
bank. Refer to frequency
publications or Internet
sites to obtain correct
LCN frequencies for the
EDACS systems you
wish to monitor. If the
EDACS system you are
programming skips
channels in the LCN
order, leave those
channels blank in your
scanner.