Filter
Top Products
70
DC – configures the channel for
DCS mode.
MO – configures the channel for
the MO mode for analog or digital
Motorola trunking system
channels, or APCO-25 trunking
system channels.
Ô
ED – configures the channel for
the ED mode for EDACS trunking
system channels.
USING THE ATTENUATOR
To reduce interference or noise
caused by strong signals, you can
reduce the scanner’s sensitivity
with the attenuator.
There are two attenuator modes in
your scanner. Normal attenuator
mode allows you to set the
attenuator on a per-channel basis.
Normal mode is useful when
individual channels are found to
be prone to interference.
Global attenuator mode applies
attenuation to every channel in the
scanner, and overrides any normal
mode attenuator settings that you
may have entered
To assign attenuation to a channel
in the scanner:
Press
ATT when the scanner is
stopped on a channel, or by
manually navigating to a channel
by using direct channel entry or
pressing the S or T arrow keys.
A
will appear in the top line of the
display. Press
ATT again to toggle
attenuation off.
Ô NOTE Ô
MO and ED modes are
not available when
performing service
searches, limit searches
and the TUNE function.