Filter
Top Products
43
when you are programming the
scanner, or any time afterwards.
You can also set a special search
code up that will instantly decode
the CTCSS or DCS code on a
received transmission. Channels
programmed with the search code
will receive all traffic on the
channel, and will instantly decode
and display any CTCSS or DCS
code that is found with the
transmission. You can then store
the found code in the channel
memory with one keystroke.
This section of the manual
describes the process for
configuring a memory channel for
CTCSS or DCS operation and
manually programming a known
code. For more information on
using the CTCSS and DCS
feature while scanning, see “Using
CTCSS and DCS” on Page 50.
To program channel memories for
CTCSS or DCS operation, follow
these steps:
1. First, enter a conventional
frequency. See “Storing
Conventional Frequencies” on
Page 30.
2. Once you have entered the
frequency, press
MODE until
the desired mode appears in
the upper left hand corner of
the display. Use CT for
CTCSS, and DC for DCS.
3. By default, the search code
(indicated with
SEARCH in the
bottom of the display) is
programmed. To program a
specific code, press
FUNC,