Filter
Top Products
86
clockwise until the noise stops.
You may find it necessary to set
the control a bit further in the
clockwise direction to prevent very
weak signals or interference from
stopping the scan operation.
Talkgroup ID Hold
You can set your scanner to follow
a trunking signal that you want to
track during scanning.
While the scanner is stopped on a
voice channel (
VC appears next to
the frequency in the display), hold
down
TRUNK until ID hold ON
appears in the scanner’s display.
To manually activate ID hold mode
on a selected ID, enter the ID list,
scroll to the desired ID, then press
FUNC TRUNK. The scanner will
initiate ID hold operation on the
selected talkgroup.
When ID hold is activated and the
scanner receives a voice channel,
the scan indication S at the first
digit in the top line changes to H to
indicate that the call is being
monitored while the scanner is in
ID hold.
To release ID hold, press
SCAN or
TRUNK.
Turning an ID Sub-Bank
On or Off
Follow these steps to turn the ID
sub-bank on or off during the
program mode:
1. Press
TRUNK repeatedly to
select the desired sub-bank.
2. Press
FUNC then 1 to toggle
the sub-bank on or off. The