Filter
Top Products
Chapter 13: KSX II Local Console
254
Full Factory Reset - Removes the entire configuration and resets the
device completely to the factory defaults. Note that any management
associations with CommandCenter will be broken. Because of the
complete nature of this reset, you will be prompted to confirm the
factory reset.
Network Parameter Reset - Resets the network parameters of the
device back to the default values (click Device Settings > Network
Settings to access this information):
IP auto configuration
IP address
Subnet mask
Gateway IP address
Primary DNS server IP address
Secondary DNS server IP address
Discovery port
Bandwidth limit
LAN interface speed & duplex
Enable automatic failover
Ping interval (seconds)
Timeout (seconds)
1. Click Reset to continue. You will be prompted to confirm the factory
reset because all network settings will be permanently lost.
2. Click OK button proceed. Upon completion, the KSX II device is
automatically restarted.
Resetting the KSX II Using the Reset Button
On the back panel of the device, there is a Reset button. It is recessed to
prevent accidental resets (you will need a pointed object to press this
button).
The actions that are performed when the Reset button is pressed are
defined in the graphical user interface. See Encryption & Share.
Note: It is recommended that you save the audit log prior to performing a
factory reset. The audit log is deleted when a factory reset is performed
and the reset event is not logged on the audit log. For more information
about saving the audit log, see Audit Log (on page 205).
To reset the device:
1. Power off the KSX II.