Filter
Top Products
Transmission Procedure
The following example shows how to dial (assuming that the ISDN G4 Option
Type 90 has been installed). The differences between this procedure and the
procedure for the base machine (refer to page 49) are as follows:
❐ You have to select G3 or G4 before you dial a number.
❐ You may have to input a subaddress for a G4 number if the destination has one.
1. Make sure that the machine is in
standby mode (see page 49).
2. Carefully place the document into the
auto document feeder.
3. Change the line type (G3/G4) to the cor -
rect setting by pressing the G4/G3 Se -
lector key on the operation panel.
4. Dial.
G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause
before the number. For an international number, place a pause after the country code.
G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have
already programmed as the subaddress key. Then enter the subaddress.
5. Yes
6. Either:
❐ Dial more numbers: go to step 4.
❐ Start the transmission: Start
Note: If the other party has not had a G4 Terminal ID programmed, you will see
"
_
=" on the screen during transmission, instead of their ID.
MEMORY TRANS. APR. 4. 12:25PM
SET DOCUMENT
MEMORY 100%
MEMORY TRANS. OPTIONS
ENTER FAX NUMBER
<G3>
MEMORY TRANS. OPTIONS
ENTER FAX NUMBER
<G4>
MEMORY TRANS. OPTIONS
PRESS YES OR CLR
.
NO
7005551234
_
To enter a subaddress, you must use a User Function Key. See page 163 for
how to program a User Function Key using Function 35.
MEMORY TRANS. OPTIONS
ENTER NO. OR
START
DEST: 2
_
See page 51 for how to dial.
You may use Speed Dial, Quick Dial,
Group Dial, or the ten-key pad.
APPENDIX
APPENDIX C. ISDN G4 OPTION TYPE 90
237