Filter
Top Products
Switch 01 - Printing of various items on received messages
Digit Purpose
0
Mark to be printed at the receiving side to distinguish messages that are sent from
your machine when it is acting as a forwarding station (Memory card or hard disk
required)
0: Off 1: On
1
Center mark 0: Off 1: On
The center mark is not printed when the machine is used for making copies
2 Reception time 0: Off 1: On
3 TSI printing 0: Off 1: On
4 Checkered mark 0: Off 1: On
5
Printing of the Command Information Line (ISDN kit required)
0: Off 1: On
This has the same effect as the TTI On/Off setting.
6, 7 Do not change these settings.
Switch 02 - Automatic printing of reports
Digit Purpose
0
Transmission result report (memory transmission)
0: Off 1: On
1 Do not change this setting.
2 Memory storage report 0: Off 1: On
3 Polling reserve report (polling reception) 0: Off 1: On
4 Polling result report (polling reception) 0: Off 1: On
5
Transmission result report (immediate transmission)
0: Off 1: On
6 Polling clear report 0: Off 1: On
7 TCR 0: Off 1: On
Switch 03 - Automatic printing of reports, Various
Digit Purpose
0
Inclusion of part of the image on the following reports: Transmission Result Report,
Memory Storage Report, Polling Clear Report, Communication Failure Report,
Transfer Result Report, Transmission Deadline Report, Polling Confirmation List
0: No 1: Yes
1 Do not change this setting.
2 Transfer Request by Tone Dial 0: Disabled 1: Enabled
3 Secure Transmission home position 0: Off 1: On
4 Batch Transmission home position 0: Off 1: On
5 Specified Image Area home position 0: Off 1: On
6 to 7 Do not change these settings.
Forwarding mark:
HOW TO USE THIS MANUAL
12