Filter
Top Products
40
Chapter 2: Basic Operation
2-2 Loading Media
Loading Sheet Media
Before attempting to load sheet media, check the following points.
Front View
Line up the right edge of the media with the guide line, and align the front edge with the location shown in the figure.
If the front edge of the media is cut at an angle, load the media so that its edge is lined up straight with the guide line.
Rear View
Remove the left-hand media flange at the back of the unit. Move the right-hand media flange at the back of the unit to a
position where it does not touch the loaded media. Drape the pulled-out media at the back between the machine and the
media guide.
Media Align here.
Guide line
Media flange Media flange
Media guide
Media
Be sure to line up the right-hand edge of the media with the guide line.
If the media is not positioned correctly when you press the [SETUP] key, the message "SHEET SET ERROR SET AGAIN"
appears on the display.