Filter
Top Products
49
Chapter 3: Using the Print Heater
3-2 Loading Media
About the Ambient Temperature During Print Heater Use
To ensure stable printing quality, we recommend use in an environment where the ambient temperature is 20˚C (68˚F)
or higher.
At low temperatures, warm-up may take a long time, or the temperature may fail to reach the preset value, or large
differences in temperature may occur. Inadequate temperature may result in coarse printing.
If the media fails to warm up sufficiently, try setting the print heater to a higher temperature. If this fails to resolve the
problem, raise the temperature of the room.
Points to Observe When Loading Media
Check and observe the following points when loading media.
Use Media With a Width of about 1 m (40 in.) or More
We recommend using media having a width of about 1 m (40 in.) or more. Media of narrower width may take a long
time to heat, or may fail to reach the preset temperature.
Also, in no event should media having a width of 50 cm (19-11/16 in.) or less be used. Doing so may lead to danger of
overheating.
Before Loading Media, Allow the Platen to Cool Down to 30˚C (86˚F) or Lower
Before loading media, switch off the print heater or set the preset temperature to 30˚C and allow the print heater to cool
down. Loading media when the print heater is 30˚C (86˚F) or more may cause the media to wrinkle or warp due to the
sudden rise in temperature.
When Printing, Use the Media Clamps
Set the height of the print heads to either "Middle" or "High," then engage the media clamps. Depending on the media,
the edges of the media may warp due to heat or the media may strike the print heads, causing jams or malfunction.