Filter
Top Products
93
Chapter 6: Menus and Keys
6-2 Description of Menus
Setting
range
—
—
ENABLE/
DISABLE
—
—
[SET
LENGTH]
0.0 to 99.9 m
(in steps of
0.1 m)
[SET AT
LOADING]
ENABLE/
DISABLE
Default
value
—
—
ENABLE
—
—
[SET LENGTH]
0.0 m (not dis-
played)
[SET AT
LOADING]
DISABLE
Function
This prints the current status of settings and other system informa-
tion.
This prompts you to replace the separating knife.
This setting determines whether priority is given to efficient ink use
or to image quality. It is displayed only when four-color inks are
used (cyan, magenta, yellow, and black). This setting is valid only
when using four-color inks and performing bidirectional printing.
Also, some high-speed print modes may not be affected by this set-
ting.
When set to [ENABLE], ink is used more efficiently, with nearly no
sacrifice in image quality.
When set to [DISABLE], priority is given to image quality over effi-
cient use of ink.
This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers (" "), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
For more information, see "4-2 Checking the Remaining Ink Level."
You can display how much of the media in use is left. Once you set
the amount of media remaining, the amount remaining is displayed
at the top menu until it reaches zero. If you cancel the setup such as
by removing the media or raising the loading lever, the amount re-
maining at that time flashes on the screen.
The amount of media remaining is not updated automatically when
you change the media. Redo the setting whenever you change the
media. You can also make the setting to display this menu automati-
cally whenever you change the media.
The remaining amount that is displayed is only an estimate, and its
accuracy is not assured.
Setting this to [ENABLE] automatically displays [SHEET REMAIN]
whenever you change the media and finish setup. This makes it im-
possible to go on to the next operation unless you redo the setting for
the amount remaining. This can be useful for keeping you from for-
getting to redo the setting when you change the media.
When you set this to [ENABLE], however, be sure to also set the
[SHEET TYPE] menu item to [OPAQUE]. When [SHEET TYPE] is
set to [CLEAR], then [SHEET REMAIN] is not displayed automati-
cally, regardless of the setting for [SET AT LOADING].
This prints the amount of media remaining that is displayed at the
top menu. You use this when you want to make a record of the re-
maining length of the media now in use. Printing the amount of me-
dia remaining before you change the media enables you to refer to
the printed record and use the value to make the setting for the re-
maining amount the next time you use the media.
Note, however, that continuing by performing the next output starts
the output on top of the portion where the amount of remaining me-
dia is printed. After you print the amount remaining, we recommend
using [SHEET CUT] key to cut off the media.
Top menu
SYSTEM REPORT
REPLACE KNIFE
ALTERNATE
HEAD
FACTORY DE-
FAULT
INK
REMAINING
SHEET REMAIN
Submenu
—
—
—
—
—
SET LENGTH
SET AT LOADING
PRINT MEMO