Filter
Top Products
43
Chapter 2: Basic Operation
2-2 Loading Media
Separating the Media
Make sure the [SETUP] LED lights up.
To cut off a printed portion from the roll, hold down the [SHEET CUT] key for at least one second.
The piece is cut off at the present location of the printing-start line. This step is not necessary when cutoff is performed
automatically by sending a media-cutoff command from the computer.
Removing the Media
1
Refer to the previous section, "Separating the
Media," and cut off the media.
2
When the SETUP LED is lighted, hold down
the [SETUP] key for at least one second.
3
Move the loading lever toward the back of the
unit.
The pinch rollers rise to release the media.
4
Remove the media.
Depending on the composition of the media, cutoff may
not be possible.
Depending on the composition of the media may remain on
the platen after cutoff. If this happens, remove it by hand.
When you're performing cutoff, do not use the [
] key to
pull the media back. Unless the end of the media has been
pulled out to a location to the front of the platen, cutoff may
not be performed smoothly.
The SETUP LED goes out
Loading lever
Knife guide
Printing-start linePrinted portion
The media is
cut off here.