RuggedCom RX1100 Network Router User Manual


 
RuggedRouter® User Guide
%C1 - Enable MNP5 compression negotiation.
%C2 - Enable V.42bis compression negotiation.
%C3 - Enable MNP5 and V.42bis compression negotiation. (default)
Line quality monitoring control
%E0 - Disable line quality monitor and auto-retrain.
%E1 - Enable line quality monitor and auto-retrain.
%E2 - Enable line quality monitor and fallback/fallforward. (default)
S registers
S6=X - Wait time for dialtone detection (2-255 seconds) (default=2)
S7=X - Wait time for carrier detection (1-255 seconds) (default=50)
S8=X - Pause time for comma in dial string (0-255 seconds) (default=2)
S9=X - Carrier detect response time (50-255 * .1 seconds) (default=6)
S10=X - Loss of carrier to hangup delay (50-255 * .1 seconds) (default=14)
S11=X - DTMF tone duration (50-255 * .01 seconds) (default=95)
S29=X - Hook flash dial modifier time (0-255 * .01 seconds) (default=70)
The last three options are presented for the Internal modem only:
Country Code selects which country's dialing system to work with. If this is not set
correctly the modem might not be able to dial or connect.
Speaker Volume controls how load the modem speaker is.
Speaker Mode controls whether the speaker on the modem is on or off.
Modem PPP Client Connections
To edit an existing connection, click the “Edit” link for that connection.
To create a new connection click “Add new” link.
To have the router automatically dial a connection at boot time and keep it always
active, select which connection should be used from the drop down list of available
connection profiles in the “Connect at boot” list.
98 RuggedCom
Figure 88: Modem PPP Client Connections