Filter
Top Products
T
ROUBLESHOOTING
6.8
Load Document
You have attempted to set up
a copy or fax operation with
no document loaded.
Load a document and try again.
Low Heat Error
There is a problem in the
fuser unit.
Unplug the power cord and plug it
back in. If the problem persists,
please contact a service
representative.
Open Heat Error
[Over Heat]
[LSU Error]
A problem has occurred in
the LSU (Laser Scanning
Unit).
Unplug the power cord and plug it
back in. If the problem persists,
please call for service.
Memory Full
The memory is full. Delete unnecessary documents,
retransmit after more memory
becomes available or split the
transmission into more than one
operation.
[No Answer]
The remote fax machine has
not answered after several
redial attempts.
Try again. Make sure that the
remote machine is operational.
No. Not
Assigned
The one-touch or speed dial
location you tried to use has
no number assigned to it.
Dial the number manually using the
number keypad or assign the
number. For storing a number, see
page 2.15.
[No Paper]
Add Paper
The paper tray has run out of
paper.
Load paper in the paper tray. See
page 1.8.
Operation Not
Assigned
You are in the Add/Cancel
operation, but there are no
jobs waiting.
Check the display to see if there are
any scheduled jobs. The display
should indicate them in Standby
mode, for example, DelayFax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 6.3.
[Paper Jam 1]
Open/Close Door
• Paper has jammed in the
paper exit area.
• A paper jam has occurred in
the manual feeder or the
machine detects non-feeding
from the manual feeder.
• Clear the jam. See page 6.5.
• Clear the jam. See page 6.6.
[Paper Jam 2]
Check Inside
Paper has jammed in the
fuser area.
Clear the jam. See page 6.4.
[Power Failure]
Power has turned off then on
and the machine’s memory
has not been saved.
You need to restart the job you were
trying to do before the power
failure.
Display Meaning Suggested solutions