Filter
Top Products
Reception Functions
115
4
❒ If the Requesting Party specifies a
Group for the End Receivers and
the total number of End Receivers
exceeds 250, the Transfer Station
cannot transfer the message and
sends a Transfer Result Report to
the Requesting Party.
Reference
p.28 “Transfer Request”
Transfer Result Report
This reports whether transmission to
the End Receivers was successful or
not.
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party.
Preparation
You must program the fax number
of the requesting party in a Quick
Dial key or Speed Dial in the
Transfer Station. Also, the return
address of the machine needs to be
registered beforehand. See p.202
“Transfer Report”.
Note
❒ You can set whether a portion of
the document image is printed on
this report with User Parameters.
See p.178 “User Parameters”
(switch 04 bit 7).
-
--
-Sending the Transfer Result
Report
This machine compares the fax num-
ber of the Requesting Party with the
Requesting Party's number pro-
grammed in a Quick Dial key or
Speed Dial, and if the last five digits
of the two numbers match, it sends
the Transfer Result report to the Re-
questing Party.
• Requesting Party's own dial num-
ber:
001813-11112222
• Transfer Station's Quick Dial:
03-11112222
Multi-step Transfer
The principles of Transfer Stations
can be used to build up a multi-step
facsimile network where messages
are passed through several Transfer
Stations. By programming the End
Receivers in a Transfer Station Group,
you can enable this machine to trans-
fer messages onto other Transfer Sta-
tions.
For more information, contact your
service representative.
Reference
p.136 “Multi-step Transfer Group
Settings”