Filter
Top Products
Copying
20
2
Copying from the Bypass Tray
The optional bypass tray is required to use this function.
Use the bypass tray to copy onto spe-
cial paper (OHP transparencies, label
paper (adhesive labels), thick paper
(for example: postcards and enve-
lopes), thin paper), and copy paper
that cannot be loaded in the paper
trays.
Preparation
When the Duplex unit is attached,
the default setting is [1 Sided→
→→
→2
Sided].
When copying from the bypass
tray, select [1 Sided] for copying in
[Dup./Combine/Series] (for example
[1 Sided ]→[1 Sided] or [2 Sided]→[1
Sided]). You can change the initial
settings. ⇒ p.99 “Duplex Mode
Priority”
Important
❒ It is not possible to use inkjet pa-
per. For details about paper sizes
and paper types, see ⇒ General
Settings Guide, “Paper Type”.
❒
When paper larger than 457.3 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
Note
❒ If you do not use the standard size
copy paper or if you use special pa-
per, you should input vertical and
horizontal dimensions. ⇒ p.16
“Placing Custom Size Originals”
The sizes that you can input are as
follows.
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper.
❒ When copying on OHP transpar-
encies or paper heavier than 128
g/m
2
(about 34 lb.), you need to
specify the paper type. ⇒ General
Settings Guide,“Paper Type”
❒ The maximum number of sheets
you can load at the same time de-
pends on the paper type. The max-
imum number of sheets should not
exceed the upper limit.
A
AA
A
Open the bypass tray.
Metric
version
• Vertical: 90.0 – 305.0mm
• Horizontal: 148.0 –
457.2mm
Inch
version
• Vertical: 3.55" – 12.00"
• Horizontal: 5.83" – 18.00”
Metric
version
A3
L
, A4
L
, 8"
×
13"
L
, A5
L
Inch
version
11"
×
17"
L
, 8
1
/
2
"
×
11"
L
,
5
1
/
2
"
×
8
1
/
2
"
L
UranosC1-ENcopyA_F1_FM.book Page 20 Friday, July 26, 2002 5:01 PM