Savin C3210 All in One Printer User Manual


 
Troubleshooting
88
4
If You Cannot Make Copies as You Want
This section explains causes and remedies when copy results are not as expect-
ed.
Problem Cause Action
Copies are not stapled. There are jammed staples
in the stapler.
Remove jammed staples.
General
Settings Guide
Note
After removing jammed staples,
staples might not be ejected the
first few times you try to use the
stapler.
The number of copies ex-
ceeds the capacity of the
stapler.
Check the stapler capacity.
p.108
Supplementary Informations
Copy paper is curled. Turn the copy paper over in the
tray.
Staples are wrongly posi-
tioned.
Originals are not set cor-
rectly.
Check the correct position to place
the originals.
p.43 Staple
You cannot combine sever-
al functions.
Selected functions cannot
be used together.
Check the combination of functions
and make the settings again.
Reference
p.107 Combination Chart
When sorting, the pages
are divided into two
blocks.
The memory became full in
the middle of sorting and
the pages were delivered in
two blocks.
You can interrupt copying when the
memory becomes full.
p.105
Memory Full Auto Scan Restart
In Double Copies mode,
parts of the original image
are not copied.
Combination of original
and copy paper is not cor-
rect.
Select A3
L
for A4
K
originals and
A4 for A5 originals.
In Border, Center, or Cent-
er/Border mode, parts of
the original image are not
copied.
You set a wide erased mar-
gin.
Make the margin width narrower.
You can adjust it between 2-99mm.
p.101 Erase Border Width and
p.101 Erase Center Width
Originals are not scanned
correctly.
Set the originals correctly.
In Margin Adjustment
mode, parts of the original
image are not copied.
You set a wide erased mar-
gin.
Set a narrower margin with the User
Tools.
p.101 Front Margin:
Left/Right,
p.101 Front Mar-
gin: Top/Bottom,
p.101 Back
Margin: Left/Right,
p.101 Back
Margin: Top/Bottom
There is a lack of margin
space on the opposite side
of the binding position.
UranosC1-ENcopyA_F1_FM.book Page 88 Friday, July 26, 2002 5:01 PM