Filter
Top Products
Copying
26
2
When the {
{{
{Two-color}
}}
} key is
selected
A
AA
A
Select either [
Two Color
] or [
Red &
Black].
When [
Red & Black
] is pressed
A Press [OK].
When [Two Color] is pressed
A Press [
Change Color Setting
].
B Press [Black Portion], and then
select the color to be replaced
by black.
Note
❒ When selecting a color from
the user colors, press [User
Color].
C Press [Non-black Portion], and
then select the color to replace
the black color of the original.
D Press [OK].
Convert Colors
Copies by changing the color in the
original to a different color.
Note
❒ It is possible to specify up to 4
colors.
❒ The width of the color to be con-
verted can be adjusted in 5 levels.
If the color width is set to “Wider”
and red has been specified, colors,
which are close to magenta or or-
ange, will also be converted. The
color width can be adjusted in the
“User Tools”. ⇒ p.106 “Color Sen-
sitivity”
A
AA
A
Press the {
{{
{Full Color}
}}
} key.
B
BB
B
Press [Edit/Color Creation].
C
CC
C
Press [Color Creation].
D
DD
D
Press [Convert Color].
E
EE
E
Select the color to be converted.
F
FF
F
Select the new color to be converted.
Note
❒ You can adjust the density of
each color in 4 levels, excluding
white.
❒ When you want to change the
converted color, press from
[Conversion 1] to [Conversion 4]
and make the selection again.
❒ When changing between more than
two colors, repeat steps D and E.
UranosC1-ENcopyA_F1_FM.book Page 26 Friday, July 26, 2002 5:01 PM