Filter
Top Products
Transport & Installation
11
2 Transport & Installation
2-1 Transport
Only use a pallet jack or forklift to lift and transport the machine.
The machine is transported on a wooden pallet, which is an integral part of the packaging. The
machine is wrapped in plastic film to avoid moisture penetration.
2-2 Workspace Requirements
• This unit should be situated away from heat sources such as heat registers or stoves.
• There should be enough space around the laminator to feed-in, exit, and trim mounted and/or
laminated images.
• The background dust level must not exceed that found in a typical office/computer room
environment.
• The work area should be level, flat, and well lit.
2-3 Setup & Installation
Refer to the Unpacking/Set Up Instruction Sheet which is packed inside the crate, on top of the inner
box.
2-4 Electrical Requirements
This unit should only be connected to a power supply outlet having the voltage and amperage as
shown on the Identification Label (see Identification, 1-2). The 110VAC version of the SEAL 44 Ultra is
provided with a powercable having a NEMA 20Amp plug; the 230VAC version is provided with two
powercables: one having a BS 1363 plug, the other has a Schuko plug.
The electrical specifications of the machines are shown in 1-3, Electrical specifications.
The Seal 44 Ultra machines must be installed next to the power outlet; extension
cords are not to be used. The plug and the outlet must be easily accessible by the
operator.