Filter
Top Products
50 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Network Controls
These commands control your projector’s network status and settings. These settings
are always available, even when the projector is off.
Network Information Commands
These commands inform you of the current network settings.
Network Control Commands
These commands control your network settings.
Command Response
get netstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp dhcp=[current DHCP status]
get ipaddr ipaddr=[current IP address]
get subnetmask subnetmask=[current subnet work mask number]
get gateway gateway=[current network gateway]
get primarydns primarydns=[current primary domain name number]
get macaddr macaddr=[current MAC address]
Command Command Target Range Response
set dhcp [target] =on
=off
dhcp=[current]
set ipaddr [target] =0.0.0.0 to
=255.255.255.255
ipaddr=[current]
set subnetmask [target] =0.0.0.0 to
=255.255.255.255
subnetmask=[current]
set gateway [target] =0.0.0.0 to
=255.255.255.255
gateway=[current]
set primarydns [target] =0.0.0.0 to
=255.255.255.255
primarydns=[current]