Filter
Top Products
52 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
System Information Commands (Passive)
These commands inform you of the current system settings. These commands are
always available, even when the projector is off.
System Control Commands (Active)
These commands control the current system settings. These commands are
unavailable when the projector is off. See page 42 for setting absolute and adjustment
commands.
Command Response
get lamphrs lamphrs=[current lamp hours of operation]
get syshrs syshrs=[current projector hours of operation]
get fwverddp fwverddp=[current projector firmware version]
get fwvernet fwvernet=[current network firmware version]
get fwvermpu fwvermpu=[current processor firmware version]
get fwverecp fwverecp=[current ECP firmware version]
get vgaoutnetenable vgaoutnetenable=[current]
Command
Command Target
Range
Response
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]