Filter
Top Products
66 | CHAPTER 5 – TROUBLESHOOTING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Projector Ready Lights and Projector
Status
The SMART UF65 or SMART UF65w projector’s two indicator LED lights (Power and
Service) are located on the boom-mounted projector. Specific light sequences convey
information about the state of the projector, including errors.
IMPORTANT
After you resolve the projector’s issue, disconnect and then reconnect the
projector power cable to clear the indicator light sequence, and then reset the
projector’s status.
Flashing green Your interactive whiteboard is on and communicating with your
computer, but it’s in Mouse mode. Confirm that SMART Product
Drivers is installed on your computer.
Flashing amber Your interactive whiteboard system is turning on, is in service
mode or has detected a firmware error. On the projector’s
input/output panel, check the ECP’s 4-pin powered-mini-DIN
connection. If nothing changes after you check your connectors,
call your authorized SMART reseller
.
Power LED
(Green/Amber)
Service LED
(Red)
Message
Solid amber Off The projector is off but still receiving power
(Idle mode). Press the power button on the ECP
to turn it on.
Flashing green Off The projector is in the powering (startup) power
state. Wait for the projector to finish powering on.
Solid green Off The projector is in the operating (on) power state.
Press the power button on the ECP twice to turn
it off.
Flashing amber Off The projector is in the cooling power state. Wait for
the projector to finish cooling.
Off Flashing red The projector is overheating. The projector might
shut down automatically. See The “Projector
Overheated” Message Appears on page 68 to
troubleshoot the projector.
Interactive
Whiteboard
Ready Light
Status