SMC Networks SMC8748L2 Switch User Manual


 
P
ORT
C
ONFIGURATION
3-85
CLI – This example creates trunk 2 with ports 1 and 2. Just connect these
ports to two static trunk ports on another switch to form a trunk.
Enabling LACP on Selected Ports
Command Usage
To avoid creating a loop in the
network, be sure you enable LACP
before connecting the ports, and also
disconnect the ports before disabling
LACP.
If the target switch has also enabled
LACP on the connected ports, the
trunk will be activated automatically.
Console(config)#interface port-channel 2 4-132
Console(config-if)#exit
Console(config)#interface ethernet 1/1 4-132
Console(config-if)#channel-group 1 4-151
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#channel-group 1
Console(config-if)#end
Console#show interfaces status port-channel 1 4-140
Information of Trunk 1
Basic information:
Port type: 1000T
Mac address: 00-00-E8-AA-AA-01
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Flow control: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Current status:
Created by: User
Link status: Down
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/1, Eth1/2,
Console#
active
links
}
}
dynamically
enabled
configured
members
backup
link