SNMP C
OMMANDS
4-127
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (4-126)
snmp-server host
This command specifies the recipient of a Simple Network Management
Protocol notification operation. Use the no form to remove the specified
host.
Syntax
snmp-server host host-addr community-string
[version {1 | 2c | 3 {auth | noauth | priv}} [udp-port port]]
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you
can set this string using the snmp-server host command by itself,
we recommend that you define this string using the snmp-server
community command prior to using the snmp-server host
command. (Maximum length: 32 characters)
• version - Specifies whether to send notifications as SNMP Version
1, 2c or 3 traps.
• auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy.
• port - Host UDP port to use. (Range: 1-65535; Default: 162)
Console(config)#snmp-server location WC-19
Console(config)#