Filter
Top Products
M
IRROR
P
ORT
C
OMMANDS
4-145
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-24/48)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Table 4-40 Mirror Port Commands
Command Function Mode Page
port monitor Configures a mirror session IC 4-145
show port monitor Shows the configuration for a mirror port PE 4-146