Filter
Top Products
D 13954.01
JUNE 2006
26
TANDBERG 1700 MXP
USER GUIDE
Making Point-to-Point Video & Telephone Calls Manually
Call Handling
Select Make a Call from the menu,
or, press the green Call key on the remote control.
The TANDBERG system can make both Video calls and
Telephone calls. Telephone calls over IP may require
additional hardware and infrastructure. If in doubt contact
your administrator or your TANDBERG representative.
Do one of three things:
• Place the call by pressing OK so that the Place Call icon is selected and press OK once again
• Use the Arrow keys on the remote control to select the Place Call icon and press OK
• Press the green Call key on the remote control.
Make sure Video Call is selected (as shown here). If not,
see below for details.
Enter the dial number manually using the Numerical
Keypad.
When dialling manually, observe the guidelines given in
Numerical Keypad Features. Use
*
as separator in IP
addresses. If a system is registered on a gatekeeper or
border controller with DNS support, there are several
ways to call into the system:
<IP address>
<E.164>
<H.323 ID>
<H.323 ID>@<domain>
<E.164>@<domain>
See H.323 Settings for details
•
•
•
•
•
Touch tones Snapshot
Presets
Do as described above for a video call, but make sure
Telephone Call is selected.
Making Video Calls Manually
Making Telephone Calls Manually
Choosing Between Video and Telephone Call
Use the Arrow keys, navigate
to the Call Type icon, and click
OK. Select the type of call and
click OK to exit the submenu.