Filter
Top Products
D 13954.01
JUNE 2006
34
TANDBERG 1700 MXP
USER GUIDE
Ending a Point-to-Point Call
Ending a MultiSite Call
Ending an Ongoing Call
Call Handling
Use either of the below methods:
Press the End Call button (
Touch tones Snapshot
Presets
) on the remote control.
Press the OK/Menu button on the remote control to display the menu.
•
•
This will produce the End Call dialogue box:
Use either of the below methods:
Press the End Call button (
Touch tones Snapshot
Presets
) on the remote control again.
Press the OK/Menu button to confirm that the call is to be ended.
•
•
Use either of the below methods:
Press the End Call button (
Touch tones Snapshot
Presets
) on the remote control.
Press the OK/Menu button on the remote control to display the menu.
•
•
This will produce the End Call dialogue box:
Use either of the below methods:
Press the End Call button (
Touch tones Snapshot
Presets
) on the remote control again.
Press the OK/Menu button to confirm that the call is to be ended.
•
•
Tip! Switching off the monitor(s), using the
power button on the monitor, will not end a
call. Some systems even come with moni-
tors that cannot be switched off!
Tip! To end one or a few of the calls in a
MultiSite Meeting navigate to the name of
the call to be terminated and terminate the
call as if it were a point-to-point call.
Tip! Ending a MultiSite call can only be
done by the host. The other parties can
disconnect themselves from the conference
at any time, but they have no influence on
the rest of the conference.