Teledyne 10 Switch User Manual


 
BioOptix™ 10
Section 1 Introduction
1-2
1.2 System Specifications Table 1-1 lists the BioOptix 10 specifications.
Table 1-1 BioOptix 10 Specifications
Dimensions
a
Height: 69 cm
Width: 72 cm
Depth: 61 cm
Weight
a,b
210 kg
Power Requirement
a,c
The power switch is the
disconnect device.
100 VAC ±10%, 2.0 Amps
117 VAC ±10%, 2.0 Amps
234 VAC ±10%, 1.0 Amps
Line Frequency 50 or 60 Hz
Operating Temperature
a
5 to 40°C
Humidity
a
When connected to mains power, 95% relative humidity maximum at 5 to
40°C
Gradient Flow Rate Range 0.5 to 12 mL/min
Flow Rate Accuracy ± 5% full scale (using water)
Gradient Accuracy ± 5% full scale (using water)
Gradient Linearity ± 5% full scale (using water)
Operating Pressure 0 to 6.895 bar (0 to 100 psi)
Flow Cell Path Length 2 mm
Detector Wavelength 190 to 360 nm
Detector Noise 5 × 10
-4
AU
Detector Drift 1 × 10
-3
AU/hr
CE Conformity Specifications
a,d
Pollution Degree: 2
Installation Category: II
Maximum Altitude: 2000 meters
a. Excludes Foxy 200 Fraction Collector and Windows PC Controller. Refer to the respective manuals for these additional
specifications.
b. Dry weight of the BioOptix 10, excluding connection cables, tubing, and user-supplied buffer containers.
c. Operating voltage of the BioOptix 10 is factory set.
d. Refer to the CE Declaration of Conformity, at the back of this manual, for applicable standards and test results.