Filter
Top Products
BioOptix™ 10
Section 1 Introduction
1-6
1.3.4 BioOptix 10 Rear Panel
Controls and
Connections
Figure 1-4 BioOptix 10 rear panel controls and
connections
1
2
3
4
Table 1-5 BioOptix 10 Rear Panel Controls and Connections
Item Name Description
1 Cooling Fan Ventilates the BioOptix 10 case and cools internal components.
2 External Control Connector Connects to the Foxy 200 Fraction Collector and computer.
3 Fuses Rear Panel Accessible Fuses.
Must always be replaced with same type fuses:
100/117 VAC — 3 amp “T” type fuse
234 VAC — 1.5 amp “T” type fuses
Internal fuses are not accessible to the user and should only be
replaced by a trained service technician.
Pump Drive Board F101 — 4.0 amp “T” type fuse.
Power One PS F1 — Not Serviceable.
Lamp Drive Board F1 — .375 amp “T” type fuse.
Case Bottom Assy F4 — Not Serviceable (T2 primary).
F5 — Not Serviceable (T2 secondary).
F6 — Not Serviceable (T2 secondary).
The Column Module has an internal 1.2 amp circuit breaker and a ther-
mal breaker that should only be reset by a trained service technician.
4 AC Power Connector Connects to AC power source. A dedicated power source is recommended.
Mains power cord is the disconnect device.