Filter
Top Products
3-7
Automatic exposure adjustment
This automatic exposure level will remain in effect until you change it again by this
procedure.
The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from
the original table.
1
Press the exposure mode selector key to select the PHOTO ( )
mode.
2
Press and hold down the exposure mode selector key for approximately
5 seconds. The PHOTO ( ) indicator will go out and the AUTO
indicator will begin to blink. One or two light and dark indicators
corresponding to the automatic exposure level which has been selected
will light up.
3
Press the light ( ) or dark ( ) key to lighten or darken the
automatic exposure level as desired. If exposure level 2 is selected,
the two left-handmost indicators for that level will light up simultaneously.
Also, if level 4 is selected, the two right-handmost indicators for that
level will light up simultaneously.
4
Press the exposure selector key. The AUTO indicator will stop blinking and light up steadily.