Filter
Top Products
7-18
INSTALL THE SOFTWARE
USING THE SCANNER MODE
For problems with the scanner function, see the online manual or the help file for the driver.
Using the Button Manager
Setting up the Button Manager
The scanner driver for this unit includes an STI (Still image) driver and WIA (Windows Image Acquisition)
driver. You can install software that supports the STI driver and WIA driver to enable scanning using only
the operation panel of the unit.
The Button Manager accessory software supports the STI driver and WIA driver. Setup that is required in
Windows to use the Button Manager is explained in the following.
Windows XP
1
Click the “start” button, select “Control Panel” and click “Printers and Other Hardware”, and
then click “Scanners and Cameras” in the start menu. Right click the “TOSHIBA e-STUDIOxxx”
(where xxx is the model name of your unit) icon and click “Properties” in the menu that
appears.
2
In the “Properties” screen, click the “Events” tab.
3
Click the “Select an event” button and select
“ScanMenu SC1” from the pull-down menu. Select
“Button Manager (TOSHIBA Personal MFP series)”
in “Start this program” and click “Apply”.
If you prefer a specific application to be opened instead of
Button Manager, refer to page 20 of the Online manual. Do
not make the application selection in this screen.
4
Repeat Step3 to set “ScanMenu SC2” through “ScanMenu SC6” .
Click the “Select an event” button and select “ScanMenu SC2” from the pull-down menu. Select
“Button Manager (TOSHIBA Personal MFP series)” in “Start this program” and click “Apply”. Do the
same for each ScanMenu through “ScanMenu SC6”.
When the settings have been completed, click the “OK” button to close the screen. When the settings
have been completed in Windows, start the Button Manager. Adjust detailed settings and then scan
an image from the unit. For the procedures for starting Button Manager and adjusting settings, see
See “SCAN PARAMETER SETTING DIALOG BOX” (P. 7-20).