Filter
Top Products
7-19
Windows 98/Me/2000
To scan directly into an application using the Button Manager on Windows 98, Windows Me and Windows
2000. Set the Event Manager properties to send only to Button Manager as shown below.
1
Click the “Start” button, select “Control Panel” from “Settings”, and open “Scanners and Cameras”
in start menu.
In Windows Me, it occasionally happens that the “Scanners and Cameras” icon does not
appear immediately after installation of the MFP driver is completed. If the icon does not
appear, click “View all Control Panel options” in the Control Panel and display the “Scanner
and Cameras” icon.
2
Select “e-STUDIOxxx” (where “xxx” is the model name of your unit), and click the “Properties”
button.
In Windows Me, right click “e-STUDIOxxx” (where “xxx” is model name of your unit) and click “Properties”
in the menu that appears.
3
In the “Properties” screen, click the “Events” tab.
4
Click the “Scanner events” button and select “ScanMenu SC1”
from the pull-down menu. Select “Button Manager (TOSHIBA
Personal MFP series)” in “Send to this application” and click
“Apply”.
If other application are shown, deselect the checkboxes for
the other applications and leave only the Button Manager
checkbox selected.
5
Repeat Step4 to set “ScanMenu SC2” through “ScanMenu SC6”.
Click the “Scanner events” and select “ScanMenu SC2” from the pull-down menu. Select “Button
Manager (TOSHIBA Personal MFP series)” in “Start this program” and click “Apply”. Do the same for
each ScanMenu through “ScanMenu SC6”.
When the settings have been completed, click the “OK” button to close the screen. When the settings
have been completed in Windows, start the Button Manager. Adjust detailed settings and then scan
an image from the unit. For the procedures for starting Button Manager and adjusting settings, see
“Scan Parameter Setting Dialog Box” (Next page).