Filter
Top Products
2. SYSTEM MODE EO13-33002
2.1 Self-diagnostic Test
2-13
(5) SDRAM Capacity
SDRAM 16MB
(6) Sensor 1 Check
The status of the Strip Sensor, Ribbon Feed Motor Sensor, Ribbon Take-up Motor Sensor, Cutter
Home Position Switch, Head Up Sensor, and Pinch Roller Sensor are printed.
SENSOR1 00000000, 0 1 1 1 0 0 1 1
Sensor/Switch Print status description
Pinch roller sensor Detects the Open or Close status of the pinch roller. Only when
the pinch roller and the print head are both closed, printing is
performed.
Head up sensor Detects the Open or Close status of the print head. Only when
the pinch roller and the print head are both closed, printing is
performed.
Cutter home position sensor Indicates whether or not the cutter is at the home position.
Ribbon take-up motor sensor
Ribbon feed motor sensor
Controls ribbon motor rotation by detecting the slit on the ribbon
take-up motor and the ribbon feed motor. Indicates the position
of the slit sensor.
Strip sensor Detects whether or not the label is at the paper outlet in strip
printing mode. When the label is not detected, the printer feeds
the label at the print start position.
Capacity of DRAM
System/drawing memory
Pinch roller sensor status
1: The pinch roller is closed.
NOTE: If either the pinch roller or the
p
rint head
is opened, printing is not performed.
Cutter home position sensor status
0: Home position
1: Other position
Fixed to 0.
Ribbon take-up motor sensor status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.
Fixed to 0.
Ribbon feed motor sensor status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.
Fixed to 0.
Strip sensor status
0: The label is not detected.
1: The label is detected.
Head up sensor status
1: The print head is closed.
NOTE: If either the pinch roller or the print head
is opened, printing is not performed.