Filter
Top Products
2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-25
3. The ribbon saving function is activated when there is a 20-mm or more non-print area in the media
feed direction.
4. Ribbon saving is enabled up to 4 areas per media.
5. To use the ribbon saving function for more than one area in a label/tag, there should be at least an
8-mm print area between non-print areas where the ribbon saving is performed
2.2.12 Control Code Selection
This parameter is to choose a Control Code.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTES: 1. This parameter is used to select the Control Code for the communication between the printer and
the host computer.
2. Selecting “Manual” enables you to set the control code.
When “CODE MANUAL” is selected and the [PAUSE] key is pressed, the LCD display will show the setting
screen of CONTROL CODE1 to CONTROL CODE3 as follows.
NOTES: 1. Pressing the [FEED] or [RESTART] key causes 1-byte change in the Control Code value.
2. You cannot specify the same control code with the one used for the commands.
3. You cannot use the specified Control Code for the data of the Data Command or Display Command.
<2>PARAMETER SET
CONTROL CODE1 1B
[RESTART]
[FEED]
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 01
CONTROL CODE1 00
CONTROL CODE1 FD
CONTROL CODE1 02
CODE AUTO
CODE ESC,LF,NUL
[RESTART]
[FEED]
CODE{|}
<2>PARAMETER SET
CODE AUTO
CODE MANUAL
Automatic selection
Manual selection
Manual selection
Control codes should be specified.