Filter
Top Products
2. SYSTEM MODE EO13-33002
(Revision Date: May 22, 2007)
2.6 RAM Clear
2-63
When the Maintenance Counter Clear is completed, the following message appears.
Turn off the printer to exit this mode.
Initial values after clearing the maintenance counter (MANTE.CNT CLEAR)
Item Initial Value
Media distance covered 0 km
Print distance 0 km
Cut count 0 time
Head up and down cycle count 0
Ribbon motor drive time 0 hours
Solenoid drive time for head up 0 hours
RS-232C hardware error count 0
System error count 0
Momentary power failure count 0
Maintenance counter items to be cleared according to the mode
(B-SX8T-TS12-QM-R (V1.1 or greater))
Mode
Item
ALL FEED&PRINT CUT
Media distance covered O O ---
Print distance O O ---
Cut count O --- O
Head up and down cycle count O --- ---
Ribbon motor drive time O --- ---
Solenoid drive time for head up O --- ---
RS-232C hardware error count O --- ---
System error count O --- ---
Momentary power failure count O --- ---
Note: “O” indicates the item to be cleared.
2.6.4 Parameter Clear
Press the [PAUSE] key to show the destination code selection display.
Press the [PAUSE] key to perform a Printer Parameter Clear.
When the Printer Parameter Clear is completed, the following message appears.
Turn off the printer to exit this mode.
PARAMETER CLEAR
*** COMPLETE ***
***QM TYPE***
Standard for worldwide
***CND TYPE***
B-SX8T-TS15-CND-R only (Japanese model)
*** COMPLETE ***
[FEED] or [RESTART] key