Filter
Top Products
2. SYSTEM MODE EO13-33002
(Revision Date: Jul. 24, 2008)
2.6 RAM Clear
2-64
Initial values after clearing the parameters (PARAMETER CLEAR)
Item Initial Value
Feed amount fine adjustment (PC), (KEY) 0 mm
Cut (Strip) position fine adjustment (PC), (KEY) 0 mm
Reverse feed amount fine adjustment (PC), (KEY) 0 mm
Print tone fine adjustment (Thermal transfer), (PC), (KEY) 0
Print tone fine adjustment (Thermal direct), (PC), (KEY) 0
Ribbon take-up motor driving voltage fine adjustment (PC), (KEY) 0
Ribbon feed motor driving voltage fine adjustment (PC), (KEY) 0
Threshold manual fine adjustment for the black mark sensor 1.0V
Threshold manual fine adjustment for the feed gap sensor 1.4V
X axis fine adjustment (KEY) 0 mm
Character code and zero font code PC-850, “0” (without slash)
Baud rate 9600 bps
Data length 8 bits
Stop bit 1 bit
Parity None
Flow control code XON/XOFF + READY/BUSY (DTR) protocol:
(XON output when the power is on,
XOFF output when the power is off)
LCD message language English
Forward wait OFF
Head up cut in cut issue mode OFF (Not activated)
B-SX6T-TS12-QM-R OFF (Not activated) Ribbon saving function
B-SX8T-TS12-QM-R ON (Activated)
(When the head lever is set to the tag position.)
Control code AUTO
Ribbon type TRANS (Transparent ribbon)
Strip wait status OFF
Feed key function FEED
Kanji code type TYPE1
Euro code B0H
Auto print head check OFF
ACK/BUSY timing TYPE 1
Web printer function OFF
Media sensor CENTER (Fixed sensor)
Input prime (Reset operation when INIT signal is ON.) OFF: Unavailable
Strip wait status OFF
Expansion I/O mode Standard mode
Plug & Play OFF
Print processing at the label/ribbon end detection The printer stops an issue operation.
Pre strip OFF: Unavailable
Reverse feed speed 3 inches/second
Maxi code specification selection TYPE1 (Compatible with the current version)
Strip motor torque R0 (For standard papers)
Stabilizer function ON (Enabled only in direct thermal mode)
Automatic calibration OFF
LAN enable/disable LAN: Enabled, SNMP: Enabled
Status response ON