Filter
Top Products
2. SYSTEM MODE EO13-33002
2.3 Printer Parameter Fine Adjustment
2-40
(b) Operation example
Issue count: 3, Cut interval: 1
• Example of Strip Position Fine Adjustment
When setting +3.0 mm
Compared with “+0.0mm” position, the stop
position after printing is shifted forward.
When setting +0.0 mm
When setting –3.0 mm
Compared with “+0.0mm” position, the stop
position after printing is shifted backward.
NOTE: The print stop position when printing the label in strip
mode varies according to label length as the strip mode
printing stops so that the edge of the strip shaft is 4 mm
from the middle of the gap. This is because the gap
length is programmed as 2 mm. When the gap length
is 5 mm or more, the effective print length should be set
to the value obtained by subtracting 2 mm from the
label pitch, that is, set the gap length to 2 mm. If the
print format hangs over the gap as a result, correct
the
print start position.
(1) Idling
(4) Printing Label B has been finished.
(7) Label C is fed to the cut position, then this
Label is cut off.
(2) Printing Label A has been finished.
(3) While Label B is being printed, the front gap of
label A is cut off.
(8) Label C is fed backward to the home position.
(6) Printing Label C has been finished.
A
B
A
Print head
position
Cut
position
A
B
C
B
C
A
B
A
C
B
A
C
C
B
B
A
C
(5) While Label C is being printed, the front gap of
label B is cut off.
L
a
b
e
l
P
r
i
n
t
H
ea
d
Platen
Strip Plate
B
ac
ki
ng
P
ape
r
3
mm
Stop position afte
r
printing
St
op pos
iti
on a
ft
e
r
printing
St
op pos
iti
on a
ft
e
r
printing
3
mm