Filter
Top Products
2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-33
2.2.26 Pre-Strip Selection
This parameter is to choose whether to activate the Pre-strip function.
When this parameter is set to ON (Available), the top edge of a label is separated (pre-stripped) from the
backing paper before the label is printed. This function is intended to make the strip issue easier in case the
labels are hard to strip due to the label intensity, adhesive power, or the printing speed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
NOTE: This parameter is fixed to OFF.
Press the [PAUSE] key to skip.
2.2.27 Reverse Feed Speed Selection
This parameter is to choose a reverse feed speed.
In the strip issue, the back feed speed of 3”/sec. may cause a shortage of feed amount due to a lack of
torque, slippery media surface, etc. In such case, reduce the back feed speed to 2”/sec. to secure the feed
amount.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Back Feed Speed, press the [PAUSE] key.
2.2.28 Maxi Code Specification Selection
This parameter is to choose a Maxi code specification.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Maxi code specification, press the [PAUSE] key.
<2>PARAMETER SET
PRE PEEL OFF OFF
<2>PARAMETER SET
BACK SPEED STD
BACK SPEED STD
BACK SPEED LOW
[RESTART]
[FEED]
STD: 3 inches/second
LOW: 2 inches/second
<2>PARAMETER SET
MAXI CODE TYPE1
MAXI CODE TYPE1
MAXI CODE TYPE2
[RESTART]
[FEED]
TYEP1: Compatible specification with the existing version
TYPE2: Specification for specific home delivery company