Filter
Top Products
2. SYSTEM MODE EO13-33002
(Revision Date: Jul. 24, 2008)
2.9 RFID Module Setting
2-82
2.9.10 RFID Adjustment for Retry
If the printer fails to write data to an RFID tag, it feeds the RFID tag forward or backward for a specified
length, then starts retrying to write data. If “0” is set for this parameter, however, a feed or a reverse feed of
the RFID tag is not performed.
As a write error may be caused by a misalignment of an RFID tag and the antenna, adjust the RFID tag
position so that it stops just above the antenna.
Please obtain a value to be set for this parameter by using an RFID Analyze Tool (See Section 5.)
When “ADJ RETRY +00” is displayed, press the [PAUSE] key.
Use the [FEED] or [RESTART] key to select a desired option. (Range: -99mm to +99mm)
[FEED] key: Pressing the [FEED] key one time causes a –1mm change, up to –99mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +1mm change, up to +99mm.
• Adjustment in negative (−) direction
• Adjustment in positive (+) direction
After selecting the adjustment value, press the [PAUSE] key.
<10>RFID
ADJ RETRY +00
[RESTART]
[FEED]
ADJ RETRY +99
ADJ RETRY +01
ADJ RETRY +00
ADJ RETRY -99
Feed Direction
A
ntenna
RFID Tag
Feed Direction
A
ntenna
RFID Tag