Filter
Top Products
2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-23
2.2.8 LCD Language Selection
This parameter is to choose a language in which the LCD message is displayed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a language, press the [PAUSE] key.
2.2.9 Auto Forward Wait Selection
This parameter is to choose whether to activate the Auto Forward Wait function or not.
This function, used in the cut mode, automatically feeds the media forward for about 14 mm if there is more
than 1-second idle time after printing, to prevent the top edge of the media from curling.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
When ON is selected, pressing the [PAUSE] key will result that the LCD Message Display shows the stop
position fine adjustment value setting screen.
[FEED] key: Pressing the [FEED] key one time causes a –0.1 mm change, up to –5.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 mm change, up to +5.0 mm.
After selecting an auto forward wait, press the [PAUSE] key.
<2>PARAMETER SET
LCD ENGLISH
[RESTART]
[FEED]
ENGLISH
ITALIAN
JAPANESE
SPANISH
DUTCH
FRENCH
GERMAN
<2>PARAMETER SET
FORWARD WAIT OFF
[RESTART]
[FEED]
FORWARD WAIT OFF
Not activated
FORWARD WAIT ON
Activated
POSITION +5.0mm
[RESTART]
[FEED]
POSITION -5.0mm
<2>PARAMETER SET
POSITION +0.0mm
POSITION +0.0mm