Filter
Top Products
4 Replacement Procedures 4.4 Bottom Cover
4-14 Satellite/E200/E205 Maintenance Manual
4.4 Bottom Cover
Removing the Bottom Cover
Remove the Bottom cover according to the following procedures and Figures 4-5 and 4-6.
1. Release the following 15 latches on the bottom cover, in that order:
- Four bottom latches on right sides.
- Two latches on right sides and three latches on left side.
- Six front latches.
2. Remove the bottom cover.
3. Open the display panel and remove the following 6 screws:
- Five M2x6 black flat head screws.
- One M2x5 white flat head screw.
4. Remove the left and right side hinge cover.
5. Turn the computer upside down and remove following 9 seal tapes:
- Four seal tapes on front side.
- One seal tape on right side.
- Two seal tapes on rear side
- Two seal tapes on back side.
6. Remove the following 13 screws on the bottom cover:
- Six M2.5x5 white flat head screws.
- Three M2x6 black flat head screws.
- Two M2.5x4 black flat head screws.
- Two M2.5x6 black flat head screws.
7. Hold up the bottom cover.
8. Disconnect the RGB board cable from CN204.
9. Disconnect the LED board cable from CN205.
10. Lift up the bottom cover. Release the following 15 latches on the bottom cover, in
that order:
- Four bottom latches on right sides.
- Two latches on right sides and three latches on left side.
- Six front latches.
11. Remove the bottom cover.