Filter
Top Products
4 Replacement Procedures 4.9 ODD Bay Module
Disassembling the ODD Drive
NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it fails.
Disassemble the ODD drive according to the following procedures and Figure 4-13.
1. Remove four M2x3 black flat head screws.
2. Remove the two brackets.
3. Release the following 4 latches on the slot ODD bezel, in that order:
- Two above latches.
- Two below latches.
ODD bezel
ODD side bracket
ODD bracket
ODD
Latch
M2x3 black flat head screw
M2x3 black flat
head screw
Figure 4-13 Removing the bracket from the ODD drive
Assembling the ODD Drive
Assemble the ODD drive according to the following procedures and Figure 4-13.
1. Place the slot ODD bezel in the correct position and secure the following 4 latches, in
that order:
- Two above latches.
- Two below latches.
2. Seat the two brackets and secure it with four M2x3 black flat head screws.
4-28 Satellite/E200/E205 Maintenance Manual